14 PS600 (HR)Helical Rotor or (C)4" Submersible
Characteristics
- Lifts up to 600 Feet
- Flow rates up to 35,135 GPD or 2,930 GPH
- Simple Installation
- Maintenance Free
- High Reliablility and Long Life Expectancy
- Cost Efficient Pumping
Applications
- Livestock Watering
- Wildlife Watering
- Dirt Tank Floating Pump
- Pond Management
- Irrigation
- Residential Wells
PS600 Controller Features
- “PS600 Controller is mounted at the surface just like a standard 4" control box.”
- The controller is sealed and weatherproof (Nema 3R)
- Its purpose is to control the pump system and displays
- the operating status of the system.
- Each control is equipped with two control inputs:
- One allows for the Dry Well Probes sensor to prevent dry run or pump off conditions the other allows for a float, pressure, or remote control switch to be used.
- Once the Dry Well Probe sensor trips, the controller will shut down the pump system for 20 minutes to allow the well to recover, then it will automatically restart the system.
- The controller is equipped with overload, underload, & reverse polarity protection.
- Each contol comes with Variable Speed Control which allows the pump speed to be adjusted to reduce flow rate by approximately 30%
- Maximum Power Point Tracking for Solar Operation
- Battery Low Voltage disconnect and auto-restart after battery has recovered.
- Motor & Controller are 92% Efficient
EC Drive 600(HR)&(C) Motor Features
- Brushless DC Motor
- No Electronics inside the Motor
- Water Filled Design
- IP68, Pressure balanced, max submergence is unlimited.
- Dynamic Carbon/Ceramic Thrust Bearings
- Submerged Materials are 316 Stainless Steel
- Drinking Water Approved
4" Submersible Pump Features
- Long Life Expectancy
- Built in Check Valve
- Dry Run Protection (Dry Well Probe Sensor)
- 316 Stainless Steel Construction
Helical Rotor Pump Features
- Positive Displacement design
- Self Cleaning
- Two main parts that are field serviceable (Stator & Rotor)
- Stator is constructed of abrasion resistant rubber
- Rotor is constructed of stainless steel and then hard chrome plated to resist abrasion.
- Design is more resistant to sand damage than other pump types
PS600 Sizing Table
PS600 HR-14 (Item-No. 1070-x) Solar Operation
(Solar generator: Nominal voltage 48 to 72V DC, open circuit voltage max. 150V DC)
